The FILTAKLEEN filter
in conjunction with the main full flow filter allows the oil to pass through
a dense element which offers 1 micron filtration to clean the oil, without
removing the additives.
By adding a FILTAKLEEN
filter to your existing system you are operating on clean oil 100% of the
time.
The factory full flow
filter has too high of a flow rate to actually clean the oils' fine contaminants
which cause 80% of
major wear.
The factory filter
will protect the engine or hydraulic systems from large damaging particles
up to 25 micron.
Below 25 microns,
the particles are too small to be picked up by the main filter.
When
an engine runs on clean oil 100% of the time, engine wear is significantly
reduced and you can routinely expect to more than double the
historical or expected life of an engine.
Oil does not wear
out. Oil simply becomes contaminated due to inadequate filtration, to the
point that it needs to be drained.
The actual base stock
of the oil never wears out, only the additives in the oil become depleted
due to contamination.
With FILTAKLEEN filters
your oil will last longer and stay cleaner allowing you to extend your oil
drain intervals up to 10 times longer.
Through the use of
FILTAKLEEN filters, and your factory full-flow filters, a savings can be
realized of 75% including disposal costs.
When it comes right
down to it, cleaner oil will make an engine or a hydraulic system run more
efficient, letting your equipment last up to 8 times longer and save you
money.
All claims above can
be proven through timely oil
analysis.
